AUTONET TV

The Light Nobody Wants to See (Check Engine Light)

You've probably had your Check Engine Light go on.  Then it goes off and you figure, hey, whatever the problem was, it's gone now and I don't have to worry about it.  Well, the problem may have gone away and it may not have.

Your vehicle likely has one of these warning lights on the instrument panel: an amber light that looks like an engine or reads "Check Engine" or "Service Vehicle Soon."  If that light comes on and stays on, it usually means there's something amiss but not urgently in need of service.  (Now if it's blinking, that's another story that we'll deal with in a minute.)

Sometimes when it comes on and stays steadily lit, the problem will go away and the light will go out.  Sometimes it will stay on until you get the problem fixed.  Either way, the engine's computer will store a code that can provide clues to what's not working—or wasn't working—the way it's supposed to.

If you are just dying to know what that code is, you can buy a little code reader or take your vehicle to an auto parts store and they'll read it.  Problem is, the code offers so many options that unless you are a trained technician, you probably won't have a clue what those codes mean. 

So if you want to be sure, take it to your vehicle repair facility and have them check it.  Technicians are trained to decipher the codes and, using their experience and other diagnostic equipment, can get to the root of the problem and fix it. 

As we mentioned before, if that Check Engine light comes on and is blinking, it means a more serious engine malfunction that can damage expensive components such as the catalytic converter and even the engine itself.  It's important to have that checked by a professional as soon as possible. 

Lakeside Certified Auto
38525 Lakeshore Blvd
Willoughby, OH 44094
(440) 946-0076
http://www.lakesidecertifiedauto.com

Follow the Bouncing Vehicle (Bad Struts and Shocks)

If you hit a bump in the road and your vehicle just keeps bouncing up and down for a lot longer time than it used to, you may have bad struts and shocks.  They're the things that help to keep your vehicle's wheels and tires planted to the road surface.

But they don't last forever.  With care and depending on where and how you drive, shocks and struts should be replaced at intervals ranging from 50,000 miles/80,000 km to 100,000 miles/160,000 km.  If you drive on bumpy roads with a lot of potholes, that interval will likely be shorter. Rough surfaces can take their toll.

But how do you know if your shocks and struts are doing their job properly? The best way is to have your vehicle checked by a technician.  He or she can inspect the shock absorbers and struts for leaks, corrosion and damage.  Mounts and bushings can also go bad and they should be evaluated as well.  A thorough examination by a technician will also include looking at other suspension parts. Some may contribute to making your vehicle behave the same way if they're broken, corroded, worn or bent.     

If you need new shocks and struts, your service advisor will make sure that you get those that meet manufacturer's specifications.  That's important because they want to make sure you're getting the handling and performance engineers designed your vehicle to have.

Lakeside Certified Auto
38525 Lakeshore Blvd
Willoughby, OH 44094
(440) 946-0076
http://www.lakesidecertifiedauto.com

The Flat Fix that Fits (Tire Repairs)

Can you think of anyone who likes getting a flat tire?  Of course not.  But when one of your tires winds up with a flat or leak, whether it be from things like hitting a curb, running over a nail or picking up a sharp stone, it's time to have someone who knows what they're doing take care of it.

If you're thinking you'd like to avoid having to buy a new tire, you wonder if a patch or plug will suffice.  It depends where the puncture is and how big the hole is.  Most tire experts will say if the hole in the tire is less than ¼ of an inch or 6 mm, a patch can work.  But a patch likely won't work if the compromised part of the tire is on its shoulder or sidewall.

Here's why.  The shoulder of a tire is the part between the sidewall and tread and it's usually rounded.  It's under a lot of pressure, more than even the sidewalls. And because of that curved shape, it's hard to get a patch or plug to hold.

The sidewall is the side of the tire.  Sidewalls flex a lot when you drive, and the strain can cause a patch or plug to loosen up.  A weak spot in a sidewall is much more likely to fail and cause a blowout.  So if you have damage in the sidewall or shoulder, that tire is a good candidate for replacement, not repair.

If you have a cut or gash in your tire, it's possible the cords that strengthen your tire have also been cut.  That weak spot can spell trouble, and this type of damage usually means you should get a new one.

Your service advisor can tell you what the appropriate action is to take when you have tire damage.  You may be able to get good results with a patch, or you may have to replace one or more tires.  Your safety is riding on them.

Lakeside Certified Auto
38525 Lakeshore Blvd
Willoughby, OH 44094
(440) 946-0076
http://www.lakesidecertifiedauto.com

Power Failure (Broken Power Seat)

Know anyone who doesn't love a power seat in an SUV, a car, truck or van? They're convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem.

There are many things that cause a power seat to fail:

• Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced.
• Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy.
• Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and replace it.  But it's also important to figure out what caused the fuse to blow and deal with that, too.
• Wires.  There are wires under the seats that move when you move the seat.  Sometimes they get stretched, kinked or ripped.  In a power seat malfunction, it may be a wiring harness that needs to be replaced.
• Gears.  They help the seat move and may need to be realigned or replaced.
• Obstructions.  Yes, a piece of trash or a kid's toy has been known to jam up the works of a power seat. Taking them out of the mechanism may get your seat working again.

Most people pay extra to have power seats in a vehicle. So make sure you keep that convenient feature working. And don't forget that it's a safety issue, too.

Lakeside Certified Auto
38525 Lakeshore Blvd
Willoughby, OH 44094
(440) 946-0076
http://www.lakesidecertifiedauto.com

Going (Lug) Nuts (Lug Nut Replacement)

Here's a part of your vehicle you probably don't think about much: lug nuts.  They're what fasten your wheels onto your axles.  Pretty important, right? In order to take the wheels off your vehicle to service the brakes, rotate the tires, etc., the lug nuts have to be in good shape so a wrench will grip them tightly. 

Because lug nuts are on your wheels, they are exposed to all the elements of the road (salt, water, grime) and really take a beating. Unfortunately, some manufacturers have made them out of two different metals.  Underneath is the working part of the lug nut, made of steel.  On top is the decorative (the "good looking") part, made out of chrome, stainless steel or aluminum.  After a while, the steel part begins to corrode and expands.  That changes the shape of the outer cap, sometimes rounding off the hexagonal edges and making it hard (if not impossible) to either loosen or tighten the lug nuts since the wrench won't fit any more. 

The reason that's so important is those lug nuts must be functional, especially if you find you have a flat tire somewhere on the road.  If the wheel can't come off to be swapped with a spare, it leaves few options, one of which is your vehicle may have to be towed.  All that for corroded lug nuts!

When you take your vehicle in for service, the technician who works on it keeps an eye on many things, especially if he or she is removing wheels.  It's not unusual for your service advisor to recommend you replace several lug nuts at once since some corrode at a different rate than others. Your repair facility is trying to help you avoid driving a vehicle that has wheels that can't easily be taken off when they need to be.

The good news is there are one-piece lug nuts that don't have the problem the two-piece lug nuts have, so replacing them could eliminate that from happening again any time soon.  And that's not "nuts" at all.

Lakeside Certified Auto
38525 Lakeshore Blvd
Willoughby, OH 44094
(440) 946-0076
http://www.lakesidecertifiedauto.com